Dell powerconnect lag setup

During a conversations between two actors only a single link is used. Where this is a benefit is when you have many actors in the conversation, there are more lines to communicate with. LACP gives you protection from possible loops that can happen with miswire or misconfiguration on either end. Both are going to give you aggregation, but LAG if plugged into non-lag ports will cause a loop.

LACP only brings up the pair after successful negotiation. To continue this discussion, please ask a new question. Spiceworks Help Desk. The help desk software for IT. Best Regards. All forum topics Previous Topic Next Topic. Replies 9. Thanks for this reply, I am going to have a look at this.

Is there a way to do this via web panel? No prob. Dell-Steve A 3 Silver. There's no LAG best practices that I'm aware of, so I guess you'd need to give more specific questions. One thing to keep in mind is that the LAG does not assume the properties of the ports it includes-so you'll need to make sure if you have VLANs on the individual ports, you'll need to move them to the port-channel interface. Also, spanning-tree is important to take into account.

Before implementing a LAG, spanning tree will block one of those ports. When port-channel takes over, it effectively shuts down those ports-but it's not uncommon for one to remain blocked by spanning-tree. Learn more. Asked 2 years ago. Active 2 years ago. Viewed times. Am I missing something? Your help is appreciated. Improve this question. Yannik Z. Add a comment. Try to get connectivity working like that. Once you have this working, add the LAG configuration and duplicate the config that worked on the single ethernet link into the LAG ports.

Sign up to join this community. The best answers are voted up and rise to the top. Stack Overflow for Teams — Collaborate and share knowledge with a private group. Create a free Team What is Teams?

Learn more. Asked 10 years, 8 months ago. Active 10 years, 8 months ago. Viewed 31k times. Any assistance would be greatly appreciated. Gathering information Port g24 enabled State: forwarding Role: root Port id: Nbr Cost Sts Role PortFast Type g1 enabled Nbr Cost Sts Role PortFast Type ch3 enabled Improve this question.

Thanks - Yes, I tried that ready - made no difference from what I can see - g went offline, then online again during the changes. Have you checked mac-learning on both sides for anomalies? Mike - can you elaborate on that?